How to jump start

1. Open the hood.

2. Remove the maintenance panel by pulling it upwards to release the trim clips that hold it in place.

3. If equipped with a HEPA filter, carefully fold the HEPA filter gasket towards the front of the vehicle to gain access to the low voltage jump post.

4. Pull back the black seal to reveal the positive jump post. Remove the red cover and connect the external low voltage power supply’s red positive (+) cable to the red positive (+) jump post.

5. The HEPA filter bolt (as shown in the following image to the right) serves as the negative jump post. Connect the external low voltage power supply’s black negative (-) cable the black negative (-) jump post.

6. Turn on the external power supply (refer to the manufacturer’s instructions) for 20-30 seconds.

7. Open the driver door and wait two minutes.

8. Ensure the vehicle is able to shift into Drive.

9. Replace the maintenance panel by placing it back in its original location and pressing down until it is secure.

10. Close the hood.